15 April 2013

Special issue: "Machining of Aerospace Materials"

International Journal of Machining and Machinability of Materials 13(2/3) 2013
  • Chip segmentation behaviour and surface topography in high-speed turning of titanium alloy (Ti-6Al-4V) with eco-friendly water vapour
  • Optimisation and tool life study in drilling of titanium (Ti-6Al-4V) alloy
  • Analysis of coating performances in machining titanium alloys for aerospace applications
  • Evaluation of drilling process in Ti6Al4V using 3D FE simulation
  • Design optimisation of machining parameters for turning titanium alloys with Taguchi-Grey method
  • Influence of minimum quantity lubrication on the high speed turning of aerospace material superalloy Inconel 718
  • Development of semi empirical model for predicting material removal rate during orbital electro discharge machining of Inconel 718
  • Effects of lubrication modes on part quality during drilling 6061-T6 aluminium alloy
  • Temperature measurement during grinding of metal matrix composites
  • An experimental analysis of single pass cutting of aluminium 5083 alloy in different corner angles through WEDM
  • Usage of PCD tool in drilling of titanium/graphite hybrid composite laminate
  • Machinability and surface quality during high speed trimming of multi directional CFRP
  • Machining carbon fibre reinforced plastics: lead angle effect
  • Effect of edge trimming on failure stress of carbon fibre polymer composites

No comments: